Why We’re Swapping Old Bathroom Heaters for IP65 Infrared
Let’s be honest: those old-school halogen lamp heaters are a bit of a nightmare. We’re seeing a huge shift toward IP65 infrared systems lately, and it’s not just a trend. It comes down to two things: water and how heat actually works. Dealing with the steam If you’ve ever had a heater quit on you right when the shower gets steamy, you know the drill. Steam and water droplets sneak into the housing, fry the wiring, or pop the filament. It’s frustrating. That’s where the IP65 rating comes in. In plain English? It means the unit is sealed tight. Dust can’t get in, and water jets can’t penetrate it from any angle. We build them this way so the humidity doesn’t eat your internals or ruin the reflectors. You just get a heater that actually works without tripping your breaker the second things get misty. The magic of infrared Here is the cool part. Most heaters try to warm up the air in the room. But air is a terrible conductor. Infrared is different. It doesn’t bother with the air; it goes straight for the target. It hits your skin or the floor directly. You don’t have to wait for the whole room to heat up—you feel it the instant you flip the switch. It’s fast. Really fast. A few things to watch out for Now, you can’t just plug these into any old outlet. They pull a lot of power to get that instant heat, so you’ll need a dedicated circuit. Make sure your electrician uses the right wiring gauge, otherwise, you’ll deal with voltage drops and a heater that feels weak. And a word of caution: these things gethot. Like, really hot. If you mount them too low or too close to plastic trim or fixtures, you might actually warp your materials. Don’t skip the spacing. We always suggest keeping them at least 2.1 meters above the floor to keep everything safe. At the end of the day, making the switch just makes life easier. You can stop climbing ladders to replace burnt-out bulbs every few months and actually have a system that’s built to survive a wet bathroom.